BlueSolar DUO (remote panel)
R1,098.23
BLUESOLAR PWM DUO 12/24V-20A W/ REMOTE PANEL
Features
– PWM controller
– Charges two separate batteries. For example the starter battery and the service battery of a boat or mobile home
– Programmable charge current ratio (standard setting: equal current to both batteries)
– Charge voltage settings for three battery types (Gel, AGM and Flooded)
– Internal temperature sensor and optional remote temperature sensor
– Protected against over current
– Protected against short circuit
– Protected against reverse polarity connection of the solar panels and/or batteryColor Control GX
R5,489.27
The Color Control GX is the communication-centre of your installation. It offers at-a-glance live information, and lets you control all products connected to it. Full system control is gained – almost anywhere in the world – by accessing your Color Control GX using our free-to-use Victron Remote Management Portal (VRM).
ICC (Inverter Control Centre) / Monitoring
R4,830.00
Monitor the operation of solar panels, inverter, batteries and usage.
Upload your data to the cloud for remote monitoring and archiving of your system performance.
Storage Systems – Communication Module
The ICC (Inverter Control Centre) is the ideal solution for Pylon, Hubble and Revov when used with Axpert in an on-grid solution. The main purpose of the ICC is to provide accurate monitoring and the ability to remotely monitor when used with an Axpert or InfiniSolar inverter. Alternatively, the ICC offers the ability to connect to the Batteries BMS and by doing so the inverter can be controlled by the ICC based on the SoC reported by the BMS.
Adding the ICC greatly improves the cycling efficiency of the Axpert with the batteries as the ICC will use the SoC reported by the BMS of the battery to control when the Axpert will use grid or battery, rather than relying on the Axpert measuring the very narrow battery voltage range. By using SOC based control, the system will be able to use the full rated capacity of the battery if set to do so. This is especially useful for Axpert inverters because they can’t supply loads from mixed power sources. Maximising the energy available from the battery means the inverter will delay switching to the grid for as long as possible.
The ICC will therefore increase the overall value of the system as the full 80% DoD of the battery can be used in a self-consumption battery cycling setup. This short guide demonstrates how to setup and access the ICC as part of your storage installation.
2) Options, capabilities and limitations:
Two components will be required when using ICC with a Pylon battery:
Inverter Control Centre Module (Raspberry Pi 3 b+) INCLUDED
Pylon Communication Cable for ICC INCLUDED
Hubble battery RJ 45 Cable
Revov Usb converter cable
The ICC offers the following features:
Real-time monitoring of all the different power sources in use in a solar system (solar panels, batteries, grid power, etc).
All data is captured, stored and can be exported for a specific time period.
Specific monitoring of the batteries in use.
Can monitor up to 9 Axpert inverters in parallel.
Support for a host of different Voltronic inverters, including the new InfiniSolar 4 Super inverter.
Can monitor grid tie as well as hybrid inverters.
Hourly trend analysis of the load, the solar panels, the batteries as well as the utility consumption and/or production.
Easy setup with integrated hotspot and configuration wizard.